Available translations
loading results
Debugging a Task
Summary: Run the TaskManager project in your preferred IDE and use the Debug button on the task's menu.
You may debug any task, either a data mining task or a trading task by following these steps.
1. Run the Superalgos Client In the usual manner.
2. Open the TaskServer project in your preferred IDE, place a breakpoint in the part of the code you wish to debug, and run the TaskServer.
3. Click the Debug button on the menu of the task you wish to debug. The request will be routed to the TaskServer running in your IDE.
4. Run the trading session in case it is a trading task.
After a few seconds, execution should pause in the line where you put the breakpoint. Bear in mind the system runs slower in debug mode, thus, it may take a little while for the session to start processing, after loading all dependencies.
Troubleshooting — TOC
You just read page 14 in the topic.
1. How to Troubleshoot an Issue
3. How to Upgrade Your Existing Installation
4. Initial Setup - Node is not Recognized as an Internal or External Command
5. Initial Setup - Superalgos Failed to Connect Via Websockets
6. Perception Issues - My System Gets Slow
7. Perception Issues - There Are No Candles on The Charts
8. Perception Issues - Market Data or Indicators Seem to be Outdated
9. Perception Issues - Indicator Data Seems Wrong
10. Investigating Issues - I Think I Broke Something... How Do I Start Over?
11. Investigating Issues - On-Screen Errors and Warnings
12. Investigating Issues - Check for Errors at the Browser
13. Investigating Issues - Check the Integrity of Your Data
14. Debugging a Task